Accesso al pannello di amministrazione dell'eshop >> (Questo messaggio lo vedi solo tu!)
Ham Store Communications

OM4000HF OM Power

Amplificatore HF manuale 4000W


In promozione!



The linear amplifier OM4000HF is designed for all short wave amateur bands from 1.8 till 29 MHz (including WARC) and all modes.

It is equipped with a two pieces of ceramic tetrode FU728F.


Specification of OM4000HF:


Frequency Coverage: Amateur Bands 1.8 – 29.7 MHz including WARC
Power Output: 4000W in SSB and CW,
3000W in RTTY, AM and FM
Input Power: Usually 60 to 90W for full Output Power
Input Impedance: 50 Ohm, VSWR < 1.5 : 1
Power Gain: 17 dB
Output impedance: 50 Ohm unbalanced
Maximum output SWR: 2:1
SWR protection: Automatic switching to STBY, when reflected power is 350W or higher
Intermodulation distortion: 32dB below nominal output
Suppression of harmonics: < -50 dBc
Tubes: 2x FU728F Ceramic tetrode
Cooler: Centrifugal blower + Axial blower
Power supply: 2 x 230V – 50 Hz one or two phases
Transformers: 2 pcs of toroidal transformer 3kVA
Dimensions: 485 x 200 x 455mm (width x height x depth)
Weight: 43 kg
  - Input power too high
  - Output power too high
  - Plate voltage too low
  - Anode current too high
  - Screen current too high
  - Grid current too high
  - Mistuning of PA
  - Hot switching protection
  - Soft start for protecting your fuses
  - "switch-on blocking " at opened amplifier
BAR GRAPH INDICATORS: - Power output – 50 LEDs
  - Reflected power – 20 LEDs
  - Current at screen ( Ig2 –10 LEDs )
  - Anode voltage, anode current, tuning – 30 LEDs
LED indicators: - current at control grid ( Ig1 – 2 LEDs )
  - WAIT – preheating of tube (180 sec )
  - STBY – standby
  - OPR – operating condition
  - FAULT – failure, switching off for abt. 4 sec
Continua lo shopping! scopri altri prodotti della sezione amplificatori hf o di OM Power