| Frequency coverage: | Amateur bands (1.8 – 29.7) MHz including WARC + 50 MHz |
| Power output: | 2000+ W in SSB/CW on HF bands, 1500 W in RTTY
1500 W CW/SSB on 50 MHz |
| Drive power: | 40 to 60 W for full output power |
| Input impedance: | 50 ohm VSWR < 1.5 : 1 |
| Output amplification: | 17 dB |
| Output impedance: | 50 ohm unbalanced |
| Maximum output SWR: | 3:1 |
| SWR protection: | Automatic switching to STBY when reflected power is 350 W or higher |
| Intermodulation distortion: | better then -32 dBc |
| Suppression of harmonics: | min. -50 dBc (better than -70 dBc on 50 MHz) |
| Response speed of AUTO tune: | less than 0.5 s within same BAND, less than 3 s if out of BAND |
| Supported TRXs-CAT: | ICOM, ELECRAFT, KENWOOD, TEN-TEC ORION, YAESU,
Icom transceive protocol using by microHAM devices – CI-V OUPUT,
Flex Radios and Anan ( Apache Labs ) |
| Tube: | FU-728F ceramic tetrode |
| Cooling: | Centrifugal blower + axial blower |
| Power supply: | Switchable 220/230/240 V – 50/60 Hz or other primary voltages
(for example 200 V 50/60 Hz for Japan) |
| Transformers: | 1x toroidal transformer 3 kVA |
| Protection circuits: | - VSWR too high |
| | - Anode current too high |
| | - Anode voltage error |
| | - Screen current too high |
| | - Screen voltage error |
| | - Grid current too high |
| | - Grid voltage error |
| | - Heating voltage error |
| | - Mistuning of power amplifier |
| | - Temperature to high |
| | - Soft start for fuse protection |
| | - “switch –on blocking“ at opened amplifier |
| Indications: | 4.3" color touch screen display |
| Features: | - Automatic external Antenna switching |
| | - Automatic switching between bands |
| | - Automatic tuning within the band according to segments |
| | - Automatic switching of Band Pass Filter |
| | - Memory for faults and warning, easy maintenance |
| | - Automatic set-up anode current (BIAS) – no need to manual adjust after changing the tube |
| | - Three programmable working modes of centrifugal blower ( turbine ) + axial blower |
| | - T/R System: QSK operation with built-in vacuum RF antenna relay |
| | - Easy transport due to detachable HV transformer |
| | - Remote control - connector for LAN connection |
| | - The Power Amplifier is HF sensitive (automatic frequency reading even if no CAT) |
| | - The smallest and lightest 2000 W automatic PA on the market |
| Mechanical parameters: | 390 mm x 195 mm x 370 mm (width x height x depth) |
| Weight: | 24 kg |
Non disp.
